![cement plaster cement plaster](https://i2.wp.com/www.decorativeconcreteofvirginia.com/wp-content/gallery/exteriorstainedconcrete/P9120065.jpg)
In areas where greater thicknesses are likely, it will be necessary to apply the plaster over expanded metal lathing fixed mechanically to the concrete.įig 2: Plastering finish on concrete wall. The thickness of the finish coatĪpplied over the undercoat should be 2mm. Used in conjunction with Thistle Bond-it or other bonding agents should notĮxceed 11mm for walls and 8mm for soffits. After the plastered concrete walls have dried, you can paint them or apply wallpaper. Once the plaster is hard and set, curing must be started and continued till 7 days. Remember the thickness of the top coat should be 5 to 10mm. If the plastering is done in only 1 layer then the thickness of the plaster must be not more than 10 to 15 mm. Apply it in small strokes, making sure it is level and uniform. The layer should be in the range of 10 to 15 mm thick. Apply the PlasterĪ base coat of plaster is applied over the layer of dash with a steel trowel. The prepared plaster must be used within two hours. Mixing of PlasterĪ suitable amount of fine aggregate (sand), cement and water are mixed to obtain a required consistency of plaster for the desired work. Slurry or dash is prepared by mixing 1 part cement to 1 and 1/2 parts coarse sand with the quantity of water sufficient to obtain a runny consistency. To achieve this, a slurry is applied on the concrete surface. The texture of the concrete wall must be rough enough to hold the plaster.
#Cement plaster free
Prior to the plastering work, the surface of the concrete to be plastered is to be cleaned from peeling paint, flaking bits of old plaster and should be free from paint, oil, and dust so that the plaster can bond properly. The general steps involved in plastering of concrete surfaces are - 1.
![cement plaster cement plaster](https://washington.duraamen.com/wp-content/uploads/2019/07/exterior-concrete-resurfacing-05.jpg)
Plastering on Lightweight and No-Fines Concrete.Plastering Procedure on Concrete Surface.